Outdoor Recessed Ground Lights

A Φ35×52mm outdoor recessed ground lights rated IP67, running on DC12–24V at 1W with 90Ra CRI and a 304 stainless steel + 6063 aluminum housing. Interchangeable 20°/30°/60°/80° beam angles fit garden paths, stepping-stone and gravel walkways, pool decks and patio edges, and uplighting for trees, shrubs and ornamental plants.

1. IP67 IP Rate - Built for Wet Sites

 

Rated IP67, these outdoor recessed ground lights are sealed against dust and 30-minute immersion up to 1m. Buried flush in soil, mulch or paving, they survive sprinkler spray, pool splash and heavy rain without water ingress - so pool-deck and patio installs keep running through wet seasons instead of failing within months.

2. 304 Stainless Steel + 6063 Aluminum Housing

 

The housing pairs 304 stainless steel with 6063 aluminum, resisting rust and salt-air corrosion where standard zinc fixtures pit within a year. For coastal gardens and chlorinated pool borders, these outdoor in-ground spotlights hold their finish and structural integrity across the full 3-year warranty, cutting replacement labor on hard-to-access recessed installs.

3. 90Ra CRI - True-Color Landscape Light

 

At 90Ra color rendering index (>90 CRI), these garden ground spotlights reproduce foliage greens, brick reds and flower tones close to daylight. Uplighting trees, shrubs and ornamental plants, they avoid the washed-out yellow cast of sub-80 CRI fixtures - giving landscape designers accurate, premium-looking color on every specified plant and hardscape surface.

4. Φ35mm Body, Φ28mm Hole - Low-Profile Install

 

Measuring just Φ35×52mm with a Φ28mm mounting hole, these in-ground LED pathway lights sit nearly flush with garden paths, stepping stones and gravel walkways. The compact bore drills fast and stays trip-safe underfoot, while the recessed body disappears by day - no bulky bollards interrupting the landscape sightline.

5. 1W at DC12–24V - Safe, Low-Draw Runtime

 

Drawing 1W on DC12–24V low-voltage supply, a single transformer drives long runs of these fixtures with minimal load. The low-voltage design is safe around pools, water features and children's play areas, and cuts running cost for dusk-to-dawn pathway lighting versus 120/230V mains fixtures - with a 0.5m 2×0.75mm² rubber cable for direct-burial wiring.

Garden Ground Spotlights for Coastal & High-Salt-Fog Landscapes

Standard zinc or aluminum-only fixtures pit and corrode within 6–12 months in salt-fog coastal gardens, forcing repeated dig-outs of recessed housings. These garden ground spotlights pair 304 stainless steel with 6063 aluminum to resist salt-air corrosion across the full 3-year warranty. Ideal for seaside villas, coastal resort landscaping and chlorinated pool borders, they hold finish and IP67 sealing where cheaper fixtures fail - cutting the replacement labor that recessed installs make costly.

In-Ground LED Pathway Lights for 24/7 Dusk-to-Dawn Commercial Sites

On hotel grounds and commercial plazas running dusk-to-dawn every night, high-wattage path fixtures drive up energy bills and fail under continuous heat load. These in-ground LED pathway lights draw just 1W on DC12–24V low-voltage supply, letting one transformer power long runs of stepping-stone and gravel walkways at minimal cost. The low-draw, sealed IP67 design sustains nightly operation for resorts, parks and campus paths - lowering both running cost and maintenance downtime.

Outdoor In-Ground Spotlights for Tree & Plant Uplighting - Custom Beam Selection

Landscape projects often need multiple beam spreads - tight for tall trees, wide for shrub beds - yet single-angle fixtures force sourcing several models and washed-out sub-80 CRI color. These outdoor in-ground spotlights offer selectable 20°/30°/60°/80° beam angles at 90Ra CRI, covering grazing to area uplighting from one SKU. Our engineers provide one-on-one beam selection and support small-batch sampling, so designers spec accurate plant color without over-ordering or inventory bloat.

Outdoor Patio Ground Lights for OEM & Large-Project Bulk Procurement

For annual framework contracts and general-contractor projects, inconsistent lead times and non-standard hole sizes stall installation schedules. These outdoor patio ground lights ship in a compact Φ35×52mm body with a standard Φ28mm bore for fast, uniform drilling across patios and terraces. Our own factory supports OEM assembly, non-standard dimension customization and stable scheduled production for bulk procurement - giving contractors reliable batch delivery on landscape and hospitality builds.

FAQ

 

 

01. What is the IP rating of these outdoor recessed ground lights?

They are rated IP67 - fully dust-tight and protected against 30-minute immersion up to 1 meter deep (per IEC 60529). This lets them sit flush in soil, paving or pool decks and withstand sprinkler spray, pool splash and heavy rain without water ingress.

02. Can these in-ground lights be walked or driven over?

The Φ35×52mm body installs flush into a Φ28mm hole, sitting nearly level with paths, stepping stones and gravel walkways so foot traffic passes safely. They are rated for pedestrian walkover. They are not rated for vehicle loads - for driveways, specify a drive-over IK-rated fixture.

03. What voltage do these garden ground spotlights run on?

They run on DC12–24V low-voltage supply at 1W per fixture. The low voltage is safe around pools, water features and children's play areas, and lets a single transformer drive long runs of pathway lights. A 0.5m 2×0.75mm² rubber cable is supplied for direct-burial wiring.

04. What beam angles are available?

Four beam angles are available: 20°, 30°, 60° and 80°. Narrow 20°/30° angles suit uplighting tall trees and grazing walls; wider 60°/80° angles suit shrub beds and patio washes. This range covers accent to area lighting from a single model.

05. Are these lights suitable for coastal or saltwater pool environments?

Yes. The housing combines 304 stainless steel with 6063 aluminum to resist salt-air and chlorine corrosion, where zinc or aluminum-only fixtures pit within 6–12 months. This makes them suited to seaside landscaping and chlorinated pool borders, backed by a 3-year warranty.

06. What is the warranty and CRI?

The lights carry a 3-year warranty and a 90Ra color rendering index (>90 CRI). The high CRI reproduces foliage, brick and flower tones close to daylight, avoiding the washed-out cast of sub-80 CRI fixtures on uplit trees and plants.

 

ABOUT US

SHENZHEN YLSTAR LIGHTING CO, LIMITED is a professional manufacturer and exporter that is concerned with the design, development and production of extrior Lighting, indoor lighting, Advertising lighting and led strip solution. We are located in SHENZHEN, with conveninet transportation access. All of our products comply with international quality standards and are greatly appreciated in a variety of different markets throughout the world.

 

CERTIFICATION

Our well-equipped facilities and excellent quality control throughout all stages of production enables us to guarantee total customer satisfaction. Besides, we have received ISO90001, CCC,CE, ROHS,FCC,SAA,TUV, ETL, cETL certification. As a result of our high quality products and outstanding customer service, we have gained a global sales network reaching Europe, North America, Australia and other countries in the world.

 

WHY WORK WITH US

★Professional Sales and after-sales service Team

Experienced team, fast reaction.

Offering one-stop purchase service and one-stop lighting solution.

★Patented design

We design and manufacture led light with our own mold & technology.

★100% Inspection

All products must pass 3 times inspection before shipment.

All products are under 4 hours semi-product aging and another 4 hours finished product aging.

EXHIBITION

Hong Kong Spring Lighting Fair / Hong Kong Autumn Lighting Fair